Wells WM-TR II Installing Or Removing Satellite Tank, Water-Max Operation, Burn Hazard

M707 p/n 306692 OpManual WM-TR II

Water-Max II™ is used to dispense hot water for food preparation. The SATELLITE TANK stores five gallons of hot water for immediate use.

INSTALLING OR REMOVING SATELLITE TANK

Drain all water from SATELLITE before attempting to remove from unit. Press the HEATER SWITCH to OFF ( O )

Be sure the COVER is properly installed on the SATELLITE

Install or remove SATELLITE on Water-Max II™ shelf by lifting up on satellite faucet guard.

When installing the tank, make sure that the tank is properly positioned, that the connector is seated, and that the dispensing nozzle lowered into position in the satellite cover.

Press the HEATER SWITCH to ON ( I ). Amber REFILL light will glow and hot water will begin filling the satellite after 15 - 20 seconds.

Place an appropriate container under the faucet. Being careful not to overflow the container, pull the faucet handle to dispense hot water.

DISPENSE
NOZZLE	ON	OFF

HOT WATER

FAUCET

Fig. 5 Water-Max™ Operation

To Keep Water in Satellite Hot

Leave the heater switch ON. The satellite has an internal heater to maintain the tank temperature, and will remain ready to dispense hot water.

OPERATION

WARNING:

BURN HAZARD

Water-Max™ is designed to operate with a matching 5 gal. satellite water tank only.

Do not hold anything other than the matching satellite under the dispensing nozzle. Splashing hot water will cause serious burns.

GENERAL GUIDELINES

NEVER hold or place anything, other than the proper satellite, under the dispense nozzle. Draw water only from the hot water faucet of the satellite water tank.

NEVER attempt to remove or carry a satellite while full of water.

NEVER attempt to operate Water-Max II™ without the cover properly installed on the satellite

CAUTION:

Hot Surface

Exposed surfaces can be hot to the touch and may cause burns.

9