Installation Procedure
Hint
Tread surface of the terminal well so that
shielding may not contact other part.
4. Replace the upper part of wire controller
Be careful not to press the wiring.
Hint
1.Switch box and cord for wiring are not supplied.
2.Don't touch PCB with hand.
910. INSTALLATION OF ORNAMENT PANEL
Be sure to show customers Operation Manual and guide them how to operate unit correctly. Before installation. read also the Installation Manual of indoor unit. With this ornament , 2 or 3 air flow direction is not available.
Suitable height is 3 m.
Cautions for the installation
Accessory Pad | Pad |
1. Prepare ornament panel Handling of ornament panel
Ornament panel shall not be placed face down or against wall, neither on an uneven object.
Don' t bend carelessly the swing flap, or, problem may occur.
(1) Remove air inlet grill from ornament panel *
1 Push in the bar on inlet grill and lift it up. (Refer to Fig. 1)
2 Lift it up for about 45 degree and remove it from ornament. Tear off adhesive Bar | Fig. 1 |
tape fixing air filter on the back of the air inlet grill. (Refer to Fig. 2) |
|
(2)Remove cover plate at corner
Tear off the adhesive tape, and slide it off. (Refer to Fig. 3)
45 | Adbesive tape | |
Slide | ||
| ||
| Fig. 2 |
Fig. 3
31