Wells WVOC-4HS Hinge Adjustment, The Following Procedure Is To Be, Precautions, Frequency, Tools

HINGE ADJUSTMENT		CAUTION:
PRECAUTIONS:	None	BURN HAZARD
		Allow appliance to cool
FREQUENCY:
	Monthly, at a Minimum; or, As Needed	completely before adjusting.
TOOLS:	Phillips (+) Screwdriver
	7/16" Nut Driver
	7/8" and 1-1/8" Wrenches

THE FOLLOWING PROCEDURE IS TO BE

PERFORMED BY QUALIFIED PERSONNEL ONLY

1. Remove bottom panel to access pivot.ALIGNMENT CHECK BOTTOM PANEL

M506 p/n 304964 OpManual WVOC-4 Series Ventless Hotplate Cooktop Convection Oven

2.Gap between top of door and frame , and between bottom of door and frame must be approximately equal

Adjust height of door by loosening jamb nut, then turning pivot on its screw mounting. Clockwise lowers the door height. Re-tighten jamb nut .

3.Gap between left side of door and frame must be the same from top to bottom

Adjust door for plumb by loosening holding screws. Turn adjusting bolt to increase or decrease gap at bottom. Clockwise increases gap. Re-tighten holding screws.

4.Gap between top of door and frame must be the same from side to side

Adjust door for level by loosening holding screws, then raising or lowering latch-end of door until it is level. Re-tighten holding screws.

5.Reinstall bottom panel.

Procedure is complete

23

CLEARANCES

EQUAL

Hinge Adjustment