Weslo 831.29462 user manual Two Screws 2. Be careful not to overtighten X 2 Bolt

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not

dispose of the packing materials until assembly is completed. Refer to the drawings below to identify the small

parts used	in assembly. Assembly requires		your own phillips screwdriver (]_,	two adjustable
wrenches	_	, and wire cutters	_.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a nor- mal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

@

1 1/4" Screw (11)-4

3/8" Nut (61)-4

I Screw (2)-2 N

Handrail Washer (43)-4

1.With the help of a second person, carefully raise the Uprights (46) to the position shown. Note that the Console Base (52) and the Right Handrail (59) are joined to the right Updght with the Wire Harness (60); be careful not to pull on the Wire Harness. Set the Right Handrail on the right Upright until step 3 is completed.

Refer to the inset drawing. Position one of the Base Legs (62) against the base of the right Upright (46) as shown. Make sure that the Base Leg Pads (63) and the Front Wheel (68) are in the indicated positions. Attach the Base Leg with two 3/8" x 2" Bolts (65), two 3/8" Washers (66), and two 3/8" Nuts (61). It may be helpful to tip the treadmill as you insert the Bolts.

Attach the other Base Leg (62) in the same way.

2.Attach the Storage Latch (48) to the left Upright (46) with

two Screws (2). Be careful not to overtighten the

Screws.

3/8 x 2 Bolt (65)-4 [_

1 52"___ 60

46

68 _r-....63 65