DIAGRAM OF THE CONSOLE
spEED CON TROL
Displays
,
_¢__°EEO | T_NING | ZONES |
_p_ ON I p.p._cTl_ J_ CW
CALSI FATCALS I SPEED | DME I DISTANC_ |
Speed Control
D
ONI,qESET
HEART RATE TRAINING ZONES
M,AXF4T_N_4C _ 1_ r_ f_._ TIO e_l
f
/
._...J
BATTERY INSTALLATION
The console requires two "AA" batteries (not included). Alkaline batteries are recommended.
To install batteries, open the battery cover under the console as shown below. Press two batteries into the battery com-
partment.
Make | sure | ||
that | the neg- | ||
ative |
| ||
ends |
| of the | |
batteries | are | ||
touching | the | ||
springs. |
| ||
Close | the | Cover | |
battery | cover. | ||
STEP-BY-STEP CONSOLE OPERATION
If there is a thin sheet of clear film on the face of the console, remove it.
Before operating the console, make sure that the power cord is properly plugged in. (See HOW TO PLUG IN THE POWER CORD on page 7.)
Next, step onto the foot rails of the treadmill. Find the clip attached to the key (see the drawing above), and slide the clip onto the waistband of your clothing. Test the clip by carefully taking a few steps backward until the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip as needed.
Follow the steps on page 9 to operate the console.
8
