8.Attach the Right Handrail (82) to the Console (94) with an M5 x 16mm Screw (9), an M5 Star Washer (13), and two M4.2 x 19mm Screws (5).
Make sure that no wires are pinched. Start all three Screws before tightening any of them. Tighten the M5 x 16mm Screw and then tighten the M4.2 x 19mm Screws. Do not overtighten the Screws.
Attach the Left Handrail (79) to the other side of the Console (94) in the same way. Note: There are no wires on the left side of the Console.
Remove the plastic ties from the Right Handrail (82) and the Left Handrail (79). If necessary, press the M8 Cage Nuts (41) into place.
9. Have a second person hold the Console (94) near the Right Upright (87) and the Left Upright (not shown).
Connect the Wire Harness (83) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS
8 |
| 13 9 | 5 |
|
|
|
| ||
9 |
| 82 | 41 | 5 |
13 | 5 41 |
|
| |
|
|
| ||
| 5 |
|
| |
79 |
|
|
| |
|
|
|
| |
|
|
| 94 |
|
9 | 94 |
|
|
|
|
|
|
|
TURNED ON. Remove the wire tie from the Wire Harness. Insert the connectors and excess wire into the Right Upright (87).
Next, insert the brackets on the Right Handrail (82) and the Left Handrail (not shown) into the Right Upright (87) and the Left Upright (not shown). Make sure that no wires are pinched.
82 
Console
83 
Wire
87 | Wire |
Tie |
Console Wire 
83 
10
