4.With the help of a second person, raise the Uprights (86, 87) so the Base (91) is flat on the floor as shown. Next, position the front of the Frame (61) between the Uprights.
See the inset drawing. Locate the wire tie in- side of the lower end of the Right Upright (87). Secure the wire tie to the Wire Harness (83).
Then, pull the upper end of the wire tie until the end of the Wire Harness is extending from the upper end of the Right Upright.
5.Have a second person lift and hold the front end of the Frame (61). Hold an Upright Spacer (88) between the Right Upright (87) and the Frame. Attach the Right Upright to the Frame with an M10 x 110mm Bolt (1), an M10 Washer (12), and an M10 Star Washer (11). Do not tighten the
Bolt yet.
Repeat this step on the left side of the tread- mill.
4 | 86 83 | 87 | 83 | 87 |
| ||||
|
|
| Wire | |
|
|
|
| Tie |
61 |
|
91 |
|
5 |
|
87 |
|
| 88 |
| 12 |
11 | 1 |
| |
61 |
|
8
