Locate the Reed Switch (53) and the Magnet (51) on

 

 

 

the left side of the Pulley (55). Turn the Pulley until

 

1/8 in.

 

the Magnet is aligned with the Reed Switch. Make

 

55

sure that the gap between the Magnet and the

 

0

Reed Switch is about 1/8 in. (3 mm). If necessary,

 

53

51

loosen the M4.2 x 13mm Tek Screw (20), move the

 

Reed Switch slightly, and then retighten the Screw.

Top View

 

Reattach the Motor Hood (not shown), and run the

 

treadmill for a few minutes to check for a correct

 

 

 

speed reading.

 

 

 

PROBLEM: The walking belt slows when walked on

 

 

 

SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 13.

b. If the walking belt is overtightened, treadmill perfor-

b

 

 

mance may decrease and the walking belt may be-

2–3 in.

 

come damaged. Remove the key and UNPLUG THE

 

 

POWER CORD. Using the hex key, turn both idler

 

 

 

roller bolts counterclockwise, 1/4 of a turn. When the

 

 

 

walking belt is properly tightened, you should be able

 

 

 

to lift each edge of the walking belt 2 to 3 in. (5 to 7

 

 

 

cm) off the walking platform. Be careful to keep the

 

Idler Roller

 

walking belt centered. Then, plug in the power cord,

 

 

insert the key, and run the treadmill for a few min-

 

Bolts

 

utes. Repeat until the walking belt is properly tight-

 

 

 

ened.

 

 

 

c.If the walking belt still slows when walked on, see the front cover of this manual.

PROBLEM: The walking belt is off-center or slips when walked on

SOLUTION: a. If the walking belt has shifted to the left, first re-

 

 

 

 

 

 

 

 

move the key and UNPLUG THE POWER CORD.

 

 

a

 

Using the hex key, turn the left idler roller bolt clock-

 

 

 

 

 

 

 

 

wise 1/2 of a turn. Be careful not to overtighten the

 

 

 

 

walking belt. If the walking belt has shifted to the

 

 

 

 

right, turn the left idler roller bolt counterclockwise 1/2

 

 

 

 

of a turn. Then, plug in the power cord, insert the key,

 

 

 

 

and run the treadmill for a few minutes. Repeat until

 

 

 

 

the walking belt is centered.

 

 

 

 

 

 

 

 

b. If the walking belt slips when walked on, first re-

b

move the key and UNPLUG THE POWER CORD.

Using the hex key, turn both idler roller bolts clock-

 

wise, 1/4 of a turn. When the walking belt is correctly

 

tightened, you should be able to lift each edge of the

 

walking belt 2 to 3 in. (5 to 7 cm) off the walking plat-

 

form. Be careful to keep the walking belt centered.

 

Then, plug in the power cord, insert the key, and care-

 

fully walk on the treadmill for a few minutes. Repeat

 

until the walking belt is properly tightened.

 

21

Page 21
Image 21
Weslo CT58 Top View, Problem The walking belt slows when walked on, Walking belt. If the walking belt has shifted to