5.Place the Left Handrail (56) on the Console Assembly (91). Attach the end of the console ground wire to the in- dicated small hole in the Left Handrail with the Silver Ground Screw (8).
Then, attach the Left Handrail (56) to the Console Assembly (91) with two Console Screws (4), a Crossbar Screw (5), and a Crossbar Star Washer (12). Be careful not to pinch the ground wire.
6.Hold the Console Assembly (91) near the Right Upright (54). Touch the Right Handrail (55) to discharge any static.
Insert the end of the Wire Harness (98) into the hole in the bottom of the Right Handrail (55) and out of the large hole in the side. Then, insert the end of the Wire Harness through the two looped plastic ties.
Press the end of the Wire Harness (98) into the indicated connector on the back of the Console Assembly (91).
The end of the Wire Harness should slide easily into the connector and snap into place. If it does not, turn the end of the Wire Harness and then insert it. IF THE
CONNECTOR IS NOT INSERTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.
7.Insert the excess Wire Harness (98) down into the Right Upright (54). Then, tighten the two plastic ties around the Wire Harness, and cut off the ends of the plastic ties.
5 |
| |
5 |
| |
12 | 56 | |
| ||
4 |
| |
Small | Console Ground Wire | |
8 | ||
Hole | ||
| ||
91 |
| |
6 | Connector | |
| ||
91 |
| |
| 98 | |
| Plastic | |
| Ties | |
55 |
| |
54 | 98 | |
| ||
7 |
| |
54 |
| |
| Plastic | |
98 | Ties |
8
