MAINTENANCE AND TROUBLESHOOTING
Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual.
PROBLEM: The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a properly earthed outlet (see page 10). If an exten- sion cord is needed, use only a
b. After the power cord has been plugged in, make sure that the key is inserted into the console.
c.Check the circuit breaker located on the treadmill near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.
d.Check the on/off switch located on the treadmill near the power cord. The switch must be in the “on” position.
PROBLEM: The power turns off during use
c |
|
Tripped | Reset |
d | On |
| |
| Position |
SOLUTION: a. Check the circuit breaker located on the treadmill near the power cord (see c. above). If the cir- cuit breaker has tripped, wait for five minutes and then press the switch back in.
b.Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.
c.Remove the key from the console. Reinsert the key into the console.
d.Make sure that the on/off switch is in the “on” position (see d. above).
e.If the treadmill still will not run, please see the front cover of this manual.
PROBLEM: The displays of the console do not function properly
SOLUTION: a. Remove the key from the console and UNPLUG THE POWER CORD. Remove the five indicated Screws
(20)and the two Foot Rail Screws (25). Then, care- fully remove the Hood (65).
Locate the Reed Switch (97) and the Magnet (105) on the left side of the Pulley (104). Turn the Pulley until the Magnet is aligned with the Reed Switch. Make sure that the gap between the Magnet and the Reed Switch is about 3 mm (1/8 in.). If necessary, loosen the Screw (21), move the Reed Switch slightly, and then retighten the Screw. Reattach the Hood (not shown), and run the treadmill for a few minutes to check for a correct speed reading.
a | 65 | 20 |
|
| |
| 20 |
|
|
| 20 |
| 25 |
|
3 mm |
|
21 | 104 |
97 | 105 |
Top View
17
