12.See the lower drawing. Position the Uprights (53, 54) so that the treadmill Frame (51) is cen- tered between the Uprights.
Firmly tighten the two M10 x 110mm Bolts (1) and the four M10 x 58mm Bolts (2). Be careful not to overtighten the M10 x 110mm Bolts.
With the help of a second person, raise the Uprights (53, 54) to a vertical position.
13.Attach the Latch Housing (48) to the Left Upright (53) with two 18mm Screws (58); start both Screws before tightening either of them.
Remove the knob from the pin. Make sure that the collar and the spring are on the pin. Insert the pin into the Latch Housing (48), and tighten the knob back onto the pin.
14.Raise the treadmill to the storage position (see
HOW TO FOLD THE TREADMILL FOR STOR- AGE on page 17). Attach an Incline Leg (95) to each side of the Frame (51) with an M8 x 52mm Bolt (82), two M8 Flat Washers (72), and an M8 Nut (46) as shown. Note: do not overtighten the Nuts. The Incline Leg should be able to rotate easily.
Adjust the Incline Legs (95) to the desired in- cline (see page 16).
12 | 1 |
| |
| 2 |
| 51 |
Top View
54 |
| 51 | 53 |
|
| ||
13 |
|
|
|
|
|
| 53 |
|
| 48 |
|
| Knob |
|
|
|
| 58 | Collar |
|
|
| |
|
| Spring | Pin |
|
|
| |
14 |
|
|
|
82 |
| 72 |
|
|
| 72 | 72 |
|
| 46 |
|
72 | 95 | 46 |
|
95 |
| ||
| 51 |
| 82 |
|
|
|
15.Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex keys in a secure place. The hex key is used to adjust the walking belt (see page 20). To protect the floor or carpet, place a mat under the treadmill.
11
