Weslo WCTL29607.0 user manual Same way, See the inset drawing. Locate the wire tie

2. Have a second person hold the Base (52) in the	2
position shown.
Identify the Left Upright (53) (the Right Upright	Large
[54] has a large hole near the lower end).
	Hole
Hold the Left Upright (53) so that the two indi-	2
	54
cated small holes are on top. Attach the Left
Upright to the Base (52) with two M10 x 58mm
Bolts (2). Do not tighten the Bolts yet.	52
Attach the Right Upright (54) to the Base (52)	2
	Small Holes
in the same way.

		53
3. Slide the two Wheel Housings (45) onto the Base	3
(52). Attach each Wheel Housing with two M6 x		32
	45
58mm Bolts (13), two M6 Flat Washers (32), and		43
two M6 Nuts (43).
	13	32
			32
		45	43
		13	32
		52
4. Remove the bolts and the cardboard packaging	4
from both sides of the Hood (65). Discard the
bolts.	39	Wire Tie
Position the Base (52) as close to the front of
the treadmill as possible.
See the inset drawing. Locate the wire tie in		54
the Right Upright (54). Tie the wire tie securely	65
to the connector on the end of the Wire Harness
(39). Next, pull the opposite end of the wire tie		54
out of the upper end of the Right Upright, until
the Wire Harness is routed completely through
the Right Upright. Secure the Wire Harness to		39
the Right Upright so that it will not fall inside.
		Wire Tie
	52
	7