CONSOLE DIAGRAM
Thumb
Pulse Sensor
Note: If there are sheets of clear plastic | Key |
on the console, remove the plastic. |
Clip
FEATURES OF THE CONSOLE
The treadmill console offers a selection of features designed to make your workouts more effective.
When you select the manual mode of the console, you can change the speed of the treadmill with the touch of a button. As you exercise, the displays will provide continuous exercise feedback. You can even measure your heart rate using the
The console also offers four speed programs. Each program automatically controls the speed of the tread- mill as it guides you through an effective workout.
IMPORTANT: To prevent damage to the walking platform, always wear clean athletic shoes while using the treadmill. During the first few minutes that the treadmill is used, inspect the alignment of the walking belt, and center the walking belt if nec- essary (see page 20).
HOW TO TURN ON THE POWER
IMPORTANT: If the treadmill has been exposed to cold temperatures, allow it to warm to room tem- perature before turning on the power. If you do not do this, the console displays or other electrical components may become damaged.
Plug in the power cord (see |
|
|
|
|
|
|
|
|
|
|
|
| |
page 12). Next, locate the |
|
|
|
|
|
|
reset/off circuit breaker on |
| Reset |
|
|
|
|
the treadmill frame near the |
| Position |
|
|
|
|
power cord. Switch the cir- |
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
| |
cuit breaker to the reset po- |
|
|
|
|
|
|
|
|
|
|
|
| |
sition. |
|
|
|
|
|
|
Next, stand on the foot rails of the treadmill. Find the clip attached to the key (see the drawing above) and slide the clip onto the waistband of your clothes. Then, insert the key into the console. After a moment, the displays will light. IMPORTANT: In an emergency sit- uation, the key can be pulled from the console, causing the walking belt to slow to a stop. Test the clip by carefully taking a few steps backward; if the key is not pulled from the console, adjust the posi- tion of the clip.
13
