7.Set the Console (91)
Next, insert the console wire and tie into the hole in the side of the Right Handrail (33). Using needlenose pliers, pull the console wire out of the hole near the bracket on the Right Handrail. Then, set the Right Handrail (33) on the Console (91). Make sure that no wires are pinched. Start a Crossbar Screw (85) with a Crossbar Star Washer (7) into the Right Handrail, and then start two Console Screws (10) into the Right Handrail. Tighten the Crossbar Screw and then the two Console Screws; do not overtighten the Screws.
Attach the Left Handrail (not shown) to the Console (91) in the same way. Note: There are no wires on the left side.
8.See the upper inset drawing. If there is a guard on the end of the Console Wire, press the indi- cated tab and remove the guard with needlenose pliers. Discard the guard.
With the help of a second person, hold the Console (91) near the Right Upright (54).
Connect the Wire Harness (39) to the console wire. See the lower inset drawing. The con- nectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT
CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Insert the connectors and excess wire into the Right Upright (54).
7 | Console | 85 |
|
| Wire |
| |
| Tie | 7 | 10 |
| Bracket | ||
33 | Large |
|
|
| Hole |
|
|
| 91 |
|
|
8 |
|
| Console |
|
|
| Wire |
|
| 91 | Tab |
|
| Guard | |
| Console Wire | ||
| Console | ||
| 39 |
| Wire |
| 54 |
| 39 |
9
