DIAGRAM OF THE CONSOLE
Speed Control | Monitor Display | Pulse Display |
On/Reset
Button
Note: If there is a thin sheet of clear plastic on the console, remove it.
Key
Clip | Pulse Sensor |
CAUTION: Before operating the con- sole, read the following important precautions.
•Do not stand on the walking belt when turning on the power.
•Always wear the clip while operating the tread- mill. When the key is removed from the con- sole, the power will shut off.
•After the speed control is moved, there will be a pause before the walking belt begins to move.
•Adjust the speed in small increments until you are familiar with the treadmill.
•To reduce the risk of electric shock, keep the console dry. Avoid spilling liquid on the con- sole and use only a sealed water bottle.
STEP BY STEP CONSOLE OPERATION
Make sure that the power cord is properly plugged in (see HOW TO PLUG IN THE POWER CORD on page 7). Next, step onto the foot rails of the treadmill. Find the clip attached to the key (see the drawing above). Slide the clip onto your waistband. Follow the steps on pages 8 and 9 to operate the console.
1 Insert the key fully into the power switch.
Note: The two dis- plays will not appear when the key is first insert- ed.
Key
2 Press the On/Reset button.
The two displays will appear. Note: If batteries were just installed, the displays will already appear.
3 Resetbelt. the speed control and start the walking
Slide the speed control fully to the
left, to the "RESET" position. Next, slide the control to the right until the walking
belt begins to
move at a slow speed.
8
