HOW TO ADJUST THE RESISTANCE STRAP
If there is not enough pedalling resistance when the resistance knob is turned to the highest setting, the Resistance Strap (47) may need to be adjusted. To adjust the Resistance Strap, the left side shield must first be removed. Refer to the instructions at the left and remove the left side shield.
Next, turn the |
| |
resistance knob |
| |
to the lowest set- |
| |
ting. Locate and | 17 | |
open the Strap | ||
Buckle (46). Grip | 47 | |
the end of the | ||
| ||
Resistance Strap |
| |
(47) and pull it up |
| |
to remove any | 46 | |
slack. Whilst | ||
| ||
holding the end |
|
of the Resistance Strap, fully close the Strap Buckle. Turn the Crank (17) for a moment to make sure that there is not too much resistance. When the Resis-
tance Strap is properly adjusted, reattach the left side | ||
shield and pedal. |
| |
HOW TO ADJUST THE BELT |
| |
The exercise |
| |
cycle features a |
| |
precision belt | 16 | |
that must be | ||
| ||
kept properly |
| |
adjusted. If the |
| |
belt causes |
| |
excessive noise |
| |
or slips as you |
| |
pedal, the belt |
| |
should be |
| |
checked. To do |
| |
this, the left side shield must first be removed. Refer | ||
to the instructions on page 12 and remove the left | ||
side shield. Next, use an adjustable wrench to turn the right pedal counterclockwise and remove it. Remove the right side shield. Press down on the cen- tre of the Belt (16) between the front and rear sprock- ets. There should be from 1/4” to 3/4” of vertical movement in the centre of the Belt.
If the Belt (16) |
|
is properly |
|
adjusted, reat- | 16 |
tach the side | 34 |
shields and ped- | |
als. If the Belt | 39 |
needs to be |
|
adjusted, loosen |
|
the M10 | 37 |
Washer Nut |
(34)on each
side of the
Flywheel (39). To tighten the Belt, turn the two M6 Nuts (37) clockwise; to loosen the belt, turn the Nuts counterclockwise. Make sure that the Flywheel is straight and tighten the M10 Washer Nuts (34). Reattach the side shields and pedals.
HOW TO ADJUST THE PEDAL STRAPS
To adjust the |
|
| |
Left Pedal Strap |
|
| |
(64), first pull |
|
| |
the end of the | 45 | 28 | |
Pedal Strap off | |||
| |||
the adjustment |
|
| |
tab on the |
|
| |
Pedal (28). |
|
| |
Align a different |
|
| |
hole in the | Adjustment Tab |
| |
Pedal Strap |
|
| |
with the adjust- |
|
|
ment tab. Press the Pedal Strap onto the adjustment tab. Do the same to adjust the Right Pedal Strap (not shown).
13
