7. AttachtheT-handle(10)totheUpright(3)withtwo
M6x16mmButtonScrews(54)andtwoM6Nylon
Locknuts(55).
.Make sure that there are four Pedal Arm Bushings
(11) in each Pedal Arm (12).
Identify the Left Pedal (31), which has an "L" molded
into its bottom surface. Attach the Left Pedal to one of
the Pedal Arms (12) using three M4 x 19mm Flange
Screws (9).
Attach the Right Pedal (not shown) in the same way.
.Apply a thin film of grease to the left Handlebar (8)
and the Crank Arm (59)in the indicated locations.
Slide a Nylon Spacer (39) onto the Handlebar (8) and
a Pedal Arm Spacer (41) onto the Crank Arm (59).
Next, slide the PedalArm (12) with the Left Pedal
(31) onto the Handlebar and the Crank Arm. Secure
the Pedal Arm by tapping one 3/4" Axle Cap (43) onto
the Handlebar and another one onto the Crank Arm.
Attach the other Pedal Arm (not shown) to the right
side of the elliptical in the same way.
10.The Console (6) requires two "AA" batteries (not
included). Alkaline batteries are recommended.
To install batteries, first locate the battery clip under
the Console (6). Insert two batteries into the battery
clip as shown. Make sure that the batteries are
turned so the negative ends of the batteries
(marked "-') are touching the springs in the
battery clip.
43
10
54
55
63
10
11
\9
12
/
Grease
59
31
41
©
Battery
Clip--
@Batteries
11. Make sure that all parts of the elliptical are properly tightened. Place a mat under the elliptical to protect
the floor or carpet from damage.