Weslo WLEL19020 i,i!/ 6

Assembly requires two people. Place all parts of the elliptical in a cleared area and remove the packing mate-

rials. Do not dispose of the packing materials until assembly is completed.

Assembly requires a phillips screwdriver (_, two adjustable wrenches _ ,and a rubber

mallet r------"-_ "

Attach the Rear Stabilizer (33) to the Frame (1) with

two M10 x 75mm Carriage Bolts (47) and two M10

Nylon Locknuts (29).

Hold the Console Bracket (45) near the Upright (3)

and insert the Resistance Cable (26) down through

the Upright. Feed the Extension Wire (62) up through

the Console Bracket.

Attach the Console Bracket (45) to the Upright (3)

with two M6 x 16mm Button Screws (54) and two M6

Split Washers (38). Make sure not to pinch the

Resistance Cable (26) or the Extension Wire (62).

Making sure that the Reed Switch Wire (25)and the

Resistance Cable (58) are in the indicated slot in the

Frame (1), slide the Front Stabilizer (34) into the Frame.

Do not allow the Wire or the Cable to get pinched.

While a second person holds the Upright (3) near the

Frame (1), connect the ReedSwitch Wire (25) tothe

Extension Wire (62). Next, connect the Resistance

Cable (26) to the Lower Cable (58) in the following way:

• Refer todrawing A. Pull up on themetal bracket,

and insert the tip of the Resistance Cable (26) into

the wire clip onthe Lower Cable (58)as shown.

• Refer to drawing B. Firmly pull the Resistance

Cable (26) and slide it into the metal bracket onthe

Lower Cable (58) as shown.

• Refer to drawing C. Using pliers, squeeze the prongs

on the upper end of the metal bracket together.

Pull any slack Resistance Cable (26) out of the top of

the Upright (3). Attach the Upright to the Front

Stabilizer (34) with two M10 Nylon Locknuts (29).

Attach the Upright to the Frame (1)with two M10 x

68mm Carriage Bolts (60) and two M10 Nylon

Locknuts (29).

29"/"_," ",,_ _.-'>1 33

__47

38 _&_,._._-----54

_'_ 62- _! ;I

A t B

i,i!/ 658

Bracket_