DIAGRAM OF THE CONSOLE
Monitor Display
Water BottleSpeed Control Holder
(Water bottle
is not included)
Key
Clip
CAUTION: Before operating the console, read the following precautions.
•Do not stand on the walking belt when turn- ing on the power.
•Always wear the clip (see the drawing above) while operating the treadmill. When the key is removed from the console, the walking belt will stop.
•Adjust the speed in small increments.
•To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console and use only a sealable water bottle.
STEP-BY-STEP CONSOLE OPERATION
Before the console can be operated, two “AA” batteries must be installed (see assembly step 6 on page 6).
Follow the steps below to operate the console.
Step onto the grip tape on the treadmill. Find the clip attached to the key (see the drawing above), and slide the clip onto the waistband of your clothing. Next, in- sert the key into the console. Test the clip by care- fully taking a few steps backward until the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip as needed. Then, remove the key from the console. Follow the steps at the right and on page 9 to operate the console.
1 Insert the key fully into the power switch.
Note: Inserting the key will not turn on the dis- play. The display will turn on when the
ON/RESET button is pressed or when the
walking belt is started. (If you just installed
batteries, the display will already be on.)
8
