Weslo WLTL19323 Hold the Console 1 near the Console Plate, Handrail 16 to discharge any static

6. Hold the Console (1) near the Console Plate (4).	Touch
the Handrail (16) to discharge any static.

Locate the two wires in the Wire Harness (22) that have L-shaped connectors on the ends. Press the connectors onto the two tabs on the switch shown in inset drawing 6a. Connect the other two wires in the Wire Harness to the back of the Console (1) in the locations shown by the

arrows in drawing 6. If the connectors do not fit to- gether easily , rotate them and then connect them.

Set the Console (1) on the Console Plate (4).

IMPORTANT: Keep the Wire Harness (22) away from the battery access opening and the bosses shown above. Make sure that no wires are pinched before

you attach the Console (1) to the Console Plate (4).

Finger tighten the five 3/4” Screws (65) into the Console

Plate (4) and the Console (1).	IMPORTANT: Make sure
no wires are damaged by the Screws.	After all five

Screws have been started, firmly tighten them.

7.Attach a Wheel (15) to each side of the Base (28) with a Wheel Bolt (14) and a Nut (29).

6
	1
Boss	Boss
Battery	4
Access	22
16
	65
6a
Tabs
7
	28
29	15
	14

8. Make sure that all parts used in assembly are properly tightened before you use the treadmill.	Keep the
included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 13). To
protect the floor or carpet, place a mat under the treadmill.

7