Weslo WLTL29306.0 TOR is not Inserted PROPERLY, Console MAY be Damaged When, Power is Turned on

3. Have a second person lift and hold the front end	3
of the Frame (51). Hold a Frame Spacer (11) be-
tween the Right Upright (54) and the Frame.		54
Attach the Right Upright to the Frame with a
Frame Pivot Bolt (1), an Upright Washer (14), and
an Upright Star Washer (9). Do not tighten the
Frame Pivot Bolt yet.		11
Repeat this step on the left side of the tread-		14
mill.
		1
		9
		51
4. Set the Console Assembly (91) face down on a	4
soft surface to avoid scratching the Console		10
	22
Assembly. Set the Left Handrail (22) on the
Console as shown. Attach the Left Handrail with
two Console Screws (10).
Attach the Right Handrail (not shown) to the		10
other side of the Console Assembly (91) as de-
scribed above.
	91
5. Hold the Console Assembly (91) near the Right	5
Upright (54). Touch the Right Handrail (33) to		Connector
discharge any static.
Remove the wire from the end of the Wire	91
Harness (39). Insert the end of the Wire Harness
through the large holes in the bottom and side of
the Right Handrail (33) and through the two
looped plastic ties.
Then, press the end of the Wire Harness (39) into	33
the connector on the back of the Console		39
Assembly (91) in the location shown. See the
inset drawing. The end of the Wire Harness		Plastic
should slide easily into the connector and
		Ties
snap into place. If it does not, turn the end of the
	39
Wire Harness and then insert it. IF THE CONNEC-
TOR IS NOT INSERTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE		Connector
POWER IS TURNED ON.
	54	39
Insert the excess Wire Harness (39) downward
into the Right Upright (54). Tighten the two plastic
ties around the Wire Harness, and then cut off the
ends of the plastic ties.
	7