7.Set the Console (91) face down on a soft sur- face to avoid scratching it. Next, identify the Right Handrail (33), which has a large hole in the location shown. Hold the Right Handrail near the Console.
Next, insert the console wire into the large hole in the side of the Right Handrail (33). Using needlenose pliers, carefully grasp the connector and pull the console wire out of the hole near the bracket on the Right Handrail.
8.Set the Right Handrail (33) on the Console (91).
Make sure that the console wire is not pinched. Start a 16mm Screw (85) with an M5 Star Washer (7) into the Right Handrail, and then start two 19mm Screws (10) into the Right Handrail. Tighten the 16mm Screw and then tighten the two 19mm Screws; do not over- tighten the Screws.
Attach the Left Handrail (not shown) to the Console (91) in the same way. Note: There is not a console wire on the left side.
7 | Connector | |
Bracket | ||
Console Wire | ||
| Large | |
33 | Hole | |
| ||
| 91 | |
8 | 85 | |
Console Wire | ||
7 | ||
| 10 | |
33 |
| |
| 91 |
9
