2. Have a second person hold the Base (52) in the

2

 

 

 

 

 

 

position shown.

 

 

 

 

 

 

Identify the Left Upright (53) (the Right Upright

 

 

Large

 

 

 

 

[54] has a large hole near the lower end).

 

 

 

 

 

 

Hold the Left Upright (53) so that the two indi-

 

54

Hole

 

2

 

 

cated small holes are on top. Attach the Left

 

 

 

 

 

 

Upright to the Base (52) with two M10 x 58mm

 

 

 

 

52

 

 

Bolts (2). Do not tighten the Bolts yet.

 

 

 

 

 

2

Attach the Right Upright (54) to the Base (52) in

 

Small Holes

 

 

 

the same way.

 

 

 

 

 

 

 

 

 

 

53

 

 

3. Slide the two Wheel Housings (45) onto the Base

3

 

 

32

 

 

 

(52). Attach each Wheel Housing with two M6 x

 

45

43

 

 

58mm Bolts (13), two M6 Flat Washers (32), and

 

 

 

 

 

two M6 Nuts (43).

 

13

 

32

 

32

 

 

 

 

45

43

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

13

32

 

 

 

 

 

 

52

 

 

4. Remove the bolts (not shown) from the indicated

4

 

 

 

 

 

 

holes in the Hood (65) (only one side is shown).

 

 

 

 

 

 

Remove the cardboard packaging and discard

 

39

Wire Tie

 

 

the bolts.

 

 

 

Position the Base (52) as close to the front of

 

 

 

 

 

 

 

the treadmill as possible.

 

 

 

54

 

 

 

See the inset drawing. Locate the wire tie in

 

65

 

 

 

 

the Right Upright (54). Tie the wire tie securely

 

 

 

 

 

 

to the connector on the end of the Wire Harness

 

 

Hole

 

54

 

 

(39). Next, pull the opposite end of the wire tie

 

 

 

 

 

out of the upper end of the Right Upright, until

 

 

 

 

 

 

 

the Wire Harness is routed completely through

 

 

 

 

39

 

 

the Right Upright. Secure the Wire Harness to

 

 

 

 

 

 

the upper end of the Right Upright so that it will

 

 

 

 

 

 

 

not fall inside.

 

 

 

 

Wire Tie

 

 

 

 

 

52

 

 

 

 

 

 

 

 

 

 

 

7

 

 

 

 

 

 

Page 7
Image 7
Weslo WLTL29508.0 user manual Hold the Left Upright 53 so that the two indi, Cated small holes are on top. Attach the Left