Light Modifiers
Page 1 of 1
Setup Instructions
Apollo Portable Studio Kits
Style Series: 1070, 1075
Description
Great for
1070 and 1075 Product Contains
[1] 28” Apollo (1075 mono version includes mounting arm)
[1] 30” Silver/White Reflector
INSTRUCTIONS
To mount the Apollo onto a standard flash head, fully open the Apollo by pushing the slider up the umbrella shaft until it locks into place. Slide the shaft of the Apollo into the umbrella receptacle of the light. Fasten the setscrew down until the Apollo is held firmly in place. Pull the fabric of the front diffuser panel down and fasten the hook and loop tape to hold
in place. Fasten “X” configuration zippers tightly around the light stand.
To mount the Apollo onto a mono light, loosen the setscrew on the receptacle block at the end of the Mounting Arm. Remove the receptacle block and set aside. Slide the Mounting Arm (Style #1080) into the umbrella receptacle of the light and tighten setscrew on the light to hold in place. Fasten the receptacle block back onto the end of the Mounting Arm by tightening the setscrew. Open the Apollo by pushing
the slider up the umbrella shaft until it clicks into place. Insert the umbrella shaft of the Apollo through the receptacle block opening and tighten the setscrew. Pull the Apollo fabric down around the housing of the mono or power light letting the controls stay exposed. Slide the “X” configuration zippers into place to tightly enclose the light.
Questions? Please call 800.886.1689 or email info@fjwestcott.com. | ©F.J. Westcott Company |
