Lenovo 8098 XXX Press F3 to review the log file, XXX If a component is called out, make sure

Diagnostic Error Code	FRU/Action
006-195-XXX	Information only
Diskette interface Test aborted by user	Re-start the test, if necessary
006-196-XXX	1.	Press F3 to review the log file
Diskette interface test halt, error threshold
	2.	Re-start the test to reset the log file
exceeded
006-197-XXX	1.	If a component is called out, make sure
Diskette interface test warning
		it is connected and/or enabled
	2. Re-run test
	3. Replace the component that is called out
		in warning statement
	4. Replace the component under test
006-198-XXX	1.	If a component is called out, make sure
Diskette interface test aborted
		it is connected and/or enabled
	2. Flash the system and re-test. See “Flash
		update procedures” on page 338
	3. Go to “Undetermined problems” on page
		90
006-199-XXX	1.	Go to “Undetermined problems” on page
Diskette interface test failed, cause unknown
		90
	2. Flash the system and re-test
	3. Replace component under function test
006-25X-XXX	1.	Diskette drive cable
Diskette interface Error
	2.	Diskette drive
	3.	System board
011-000-XXX	No action
Serial port Interface Test Passed
011-001-XXX	1.	Remove external serial device, if
Serial port Presence
		present
	2. Run setup, enable port
	3.	System board
011-002-XXX	System board
011-003-XXX
Serial port Timeout/Parity error
011-013-XXX	System board
011-014-XXX
Serial port Control Signal/Loopback test
failure
011-015-XXX	1.	Wrap plug
Serial port External Loopback failure
	2.	System board
011-027-XXX	1.	Run Setup, enable port
Serial port Configuration/Setup error
	2.	Flash the system. See “Flash update
		procedures” on page 338
	3.	System board
011-03X-XXX	System board
011-04X-XXX
Serial port failure

Chapter 7. Symptom-to-FRU Index 67