Lenovo 8098 manual 030-199-XXX, XXX No action, 035-0XX-XXX RAID signal cable, XXX Information only

Diagnostic Error Code	FRU/Action
030-198-XXX	1.	If a component is called out, make sure
SCSI interface test aborted
		it is connected and/or enabled. See
		Chapter 6, “Using the Setup Utility,” on
		page 55
	2.	Flash the system and re-test. See “Flash
		update procedures” on page 338
	3.	Go to “Undetermined problems” on page
		90
030-199-XXX	1.	Go to “Undetermined problems” on page
SCSI interface test failed, cause unknown
		90
	2.	Flash the system and re-test. See “Flash
		update procedures” on page 338
	3.	Replace component under function test
035-000-XXX	No action
RAID interface Test Passed
035-0XX-XXX	1.	RAID signal cable
RAID interface Failure
	2.	RAID device
	3.	RAID adapter card, if installed
	4.	System board
035-195-XXX	Information only
RAID interface Test aborted by user	Re-start the test, if necessary
035-196-XXX	1.	Press F3 to review the log file
RAID interface test halt, error threshold
	2.	Re-start the test to reset the log file
exceeded
035-197-XXX	1.	Make sure the component that is called
RAID interface test warning
		out is connected and/or enabled. See
		Chapter 6, “Using the Setup Utility,” on
		page 55
	2.	Re-run test
	3.	Replace the component that is called out
		in warning statement
	4.	Replace the component under test
035-198-XXX	1.	If a component is called out, make sure
RAID interface test aborted
		it is connected and/or enabled. See
		Chapter 6, “Using the Setup Utility,” on
		page 55
	2.	Flash the system and re-test. See “Flash
		update procedures” on page 338
	3.	Go to “Undetermined problems” on page
		90
035-199-XXX	1.	See “Undetermined problems” on page
RAID interface test failed, cause unknown
		90
	2.	Flash the system and re-test. See “Flash
		update procedures” on page 338
	3.	Replace component under function test
071-000-XXX	No action
Audio port Interface Test Passed

74Hardware Maintenance Manual