Lenovo 8098 020-199-XXX, XXX PCI card, XXX No action, 025-00X-XXX IDE signal cable 025-01X-XXX

Diagnostic Error Code	FRU/Action
020-198-XXX	1.	If a component is called out, make sure
PCI test aborted
		it is connected and/or enabled. See
		Chapter 6, “Using the Setup Utility,” on
		page 55
	2.	Flash the system and re-test. See “Flash
		update procedures” on page 338
	3.	Go to “Undetermined problems” on page
		90
020-199-XXX	1.	Go to “Undetermined problems” on page
PCI test failed, cause unknown
		90
	2.	Flash the system and re-test. See “Flash
		update procedures” on page 338
	3.	Replace component under function test
020-262-XXX	1.	PCI card
PCI system error
	2.	Riser card, if installed
	3.	System board
025-000-XXX	No action
IDE interface Test Passed
025-00X-XXX	1.	IDE signal cable
025-01X-XXX
	2.	Check power supply voltages
IDE interface failure
	3.	Reseat IDE signal cable
	4.	IDE device
	5.	System board
025-027-XXX	1.	IDE signal cable
IDE interface Configuration/Setup error
	2.	Flash the system. See “Flash update
		procedures” on page 338
	3.	Reseat IDE signal cable
	4.	IDE device
	5.	System board
025-02X-XXX	1.	IDE signal cable
025-03X-XXX
	2.	Check power supply
025-04X-XXX
	3.	Reseat IDE signal cable
IDE Interface failure
	4.	IDE device
	5.	System board
025-195-XXX	Information only
IDE interface Test aborted by user	Re-start the test, if necessary
025-196-XXX	1.	Press F3 to review the log file
IDE interface test halt, error threshold
	2.	Re-start the test to reset the log file
exceeded
025-197-XXX	1.	Make sure the component that is called
IDE interface test warning
		out is connected and/or enabled. See
		Chapter 6, “Using the Setup Utility,” on
		page 55
	2.	Re-run test
	3.	Replace the component that is called out
		in warning statement
	4.	Replace the component under test

72Hardware Maintenance Manual