Lenovo 8098 manual Diagnostic Error Code FRU/Action 001-027-XXX Run Setup, XXX System board

Diagnostic Error Code	FRU/Action
001-027-XXX	1.	Run Setup
System Configuration/Setup error
	2.	Flash the system. See “Flash update
		procedures” on page 338
	3.	System board
001-032-XXX	System board
System Device Controller failure
001-034-XXX	1.	Reboot the system
System Device Buffer Allocation failure
	2.	Flash the system. See “Flash update
		procedures” on page 338
	3.	Run memory test
	4.	System board
001-035-XXX	System board
System Device Reset condition detected
001-036-XXX	System board
System Register error
001-038-XXX	1.	Adapter card
System Extension failure
	2.	System board
001-039-XXX	1.	Flash the system. See “Flash update
System DMI data structure error
		procedures” on page 338
	2.	System board
001-040-XXX	1.	Power-off/on system and re-test
System IRQ failure
	2.	System board
001-041-XXX	1.	Power-off/on system and re-test
System DMA failure
	2.	System board
001-195-XXX	Information only
System Test aborted by user	Re-start the test, if necessary
001-196-XXX	1.	Press F3 to review the log file
System test halt, error threshold exceeded
	2.	Re-start the test to reset the log file
001-197-XXX	1.	Make sure the component that is called
System test warning
		out is connected and/or enabled. See
		Chapter 6, “Using the Setup Utility,” on
		page 55
	2.	Re-run test
	3.	Replace the component that is called out
		in warning statement
	4.	Replace the component under test
001-198-XXX	1.	If a component is called out, make sure
System test aborted
		it is connected and/or enabled. See
		Chapter 6, “Using the Setup Utility,” on
		page 55
	2.	Flash the system and retest. See “Flash
		update procedures” on page 338
	3.	Go to “Undetermined problems” on page
		90

Chapter 7. Symptom-to-FRU Index 63