Removing and replacing the hard disk drive

1.Open the cover. See “Opening the cover” on page 138.

2.Rotate the drive bay assembly upward to gain access to the hard disk drive cable connections.

Notes:

a.If a CD drive is installed, it helps to disconnect the signal cable from the drive to access the hard disk drive cables.

b.Blue straps are provided to help when disconnecting cables.

3.Disconnect the signal and power cables from the hard disk drive.

4.Rotate the hard disk drive and bracket to the rear by pulling on the blue handle provided.

5.Lift the hard disk drive and plastic bracket up to remove. The drive is removed from the bracket by flexing the bracket.

6.Notice the orientation of the hard disk drive in the plastic bracket and remove the drive from the bracket.

7.Install the new drive into the plastic bracket and place the bracket into the slot.

8.Rotate the drive and bracket towards the front of the computer and snap it into position.

9.Reconnect the power and signal cables to the drive.

10.To complete the installation, go to “Closing the cover and connecting cables” on page 159.

Lenovo 8098 manual Removing and replacing the hard disk drive