Western Telematic IPS-800-D20, IPS-800E-D20, IPS-1600-D20, IPS-1600E-D20 manual

IPS-800/1600-D20 Series - User’s Guide

IPS UNIT

POWER INLETS

BOTTOM

PLATE

SLIDER

SCREW PLATE RECEPTACLES

Figure 4.1: IPS-800 Series Cable Keeper Installation

4.Connect the power cables to the power inlets. Check to make sure that both cables are firmly seated in the power inlet connectors.

5.Align the power cables with the two notches in the top of the slider plate, and then move the slider plate forward until both cables are held firmly in place.

6.Tighten the two screws that secure the slider plate to the bottom plate. Check to make certain that the cables are held firmly in place by the cable keepers.

4.2.Connection to Switched Outlets

Connect the power cord from your switched device to one of the AC Outlets on the IPS unit. Note that when power is applied to the IPS, the AC Outlets will be switched "ON" by default.

•IPS-800-D20 and IPS-1600-D20 (120 VAC Models): Units include two separate power busses. Each bus can support a total of 20 Amps. Each AC Outlet can support up to 15 Amps.

•IPS-800E-D20 and IPS-1600E-D20 (230 VAC Models): Units include two separate power busses. Each bus can support a total of 20 Amps. Each AC Outlet can support up to 15 Amps.

4-2