MOUNTING AND WIRING INSTRUCTIONS
CAUTION: For fixtures labeled for outdoor and wet location use, provide a
NOTE: Underwriters Laboratories (UL) does not require all fixtures to have ground wires. These fixtures meet all UL specifications.
1.Turn off power at circuit box to avoid possible electric shock.
2.Thread mounting screws (A) into universal mounting plate (B) (see fig. 1).
3.Secure universal mounting plate (B) to outlet box (C) with outlet box screws (D) (not included).
NOTE: Mounting screws (A) must be level for fixture to hang straight.
4.Identify color coding of fixture wires (see fig. 2 on page 11).
5.To connect wires, take black fixture wire (group A from fig. 2) and place evenly against black outlet box wire. Do not twist wires.
6.Fit wire connector (E) over wires and twist until there is a firm connection. If wire connector
(E)easily comes off, reattach and check again for a firm connection.
7.Repeat steps 5 and 6 with the white (group B from fig. 2) fixture and outlet box wires.
8.Partially thread green grounding screw (F) into side hole (G) on universal mounting plate
(B)(see fig. 1).
9.Wrap ground wire from fixture and ground wire (metal or green wire) from outlet box (C) around green grounding screw (F) on universal mounting plate (B).
10.Tighten green grounding screw (F). Do not over tighten.
11.Tuckwires inside outlet box (C).
FIXTURE ASSEMBLY INSTRUCTIONS
1.Place back plate (H) over mounting screws (A) (see fig. 1).
2.Secure into place with cap nuts (I).
3.To remove glass shade (J) from fixture cover (O), carefully support bottom of glass shade (J) while removing finial (K), cover (L), hex nut (M), and flat washer (N).
4.Carefully lower glass shade (J).
5.Install lamp(s). Do not exceed recommended wattage.
6.Replace glass shade (J) over nipple (P), then flat washer (N), hex nut (M), cover (L), and finial (K).
7.Turn power back on at circuit box.
4
