MOUNTING AND WIRING INSTRUCTIONS
CAUTION: For fixtures labeled for outdoor and wet location use, provide a
NOTE: Underwriters Laboratories (UL) does not require all fixtures to have ground wires. These fixtures meet all UL specifications.
1.Turn off power at fuse box to avoid possible electric shock.
2.Thread mounting screws (A) into cross bar (B) with mounting screws protruding away from outlet box (C) (see figure 1).
3.Secure cross bar (B) to outlet box (C) with outlet box screws (D) (not included).
4.Identify color coding of fixture wires (see figure 2 on page 11).
5.To connect wires, take black fixture wire (group A from fig. 2) and place evenly against black outlet box wire. Do not twist wires.
6.Fit wire connector (E from fig. 1) over wires and twist until there is a firm connection. If wire connector (E) easily comes off, reattach and check again for a firm connection.
7.Repeat steps 5 and 6 with the white (group B from fig. 2) fixture wires and outlet box wires.
8.Partially thread green grounding screw (F) into side hole (G) on cross bar (B) (see fig. 1).
9.Wrap ground wire from fixture around green grounding screw (F), leaving enough excess wire to then connect ground wire and outlet box wire with wire connector (E)
10.Tighten green grounding screw (F). Do not over tighten.
11.Tuckwires inside outlet box (C) (see fig. 1).
FIXTURE ASSEMBLY INSTRUCTIONS
1.Tuckwires inside outlet box (C) (see figure 1).
2.Place back plate (H) over mounting screws (A).
3.Secure into place with cap nuts (I).
4.Install included lamp (K) by inserting into socket base (L) and twisting to lock.
5.Turn on power at circuit breaker.
Fixture includes photocell which turns on at dusk and off at dawn, and cannot be disabled.
4
