Installing and Removing the Side Panels
To install the side panels on your spa follow the instructions below:
Step 1: Slightly lift side panel into | Step 3: Make certain that the side | Step 5: Align the thumbscrew |
place on spa frame. | panels lay above the frame at | holes located under cushion |
| the top of the basin, as shown | skirt, and screw in the |
| above. | thumbscrew. |
Step 2: Align the magnets on the | Step 4: The side panel should fit | Step 6: Install the front plate by |
frame legs with matching | under the lip of the basin, as | aligning the magnets to the |
brackets found on the inside of | shown above. | matching brackets and pressing |
the side panel. There is one set |
| into place. |
on each leg. |
|
|
To remove side panels: Reverse steps one through six.
Installing the Floor Mounting Brackets
All Platino Spas installed with gravity drain and / or hard piped to hot and cold supply lines MUST be anchored to the floor.
To install the floor mounting brackets on your spa follow the instructions below:
Step 1: Adjust the leveling feet until you have at least a ¼” gap.
Step 2: Place the floor mounting brackets on to leveling feet diagonally from each other. (2
brackets provided)
Step 3: Mark spots to be drilled. Bracket has ½” hole. If mounting to floor, use (2) 3/8” floor lag bolts with washer – not provided.
Document ID:15080000 | Rev: E | Technical Support: | Page 13 of 20 |