Whirlpool 1982 manual Installation, To REMOVEOVENDOOR-SELF-CLEANINGMODELS, Viewa

1.If local codes permit connection of the frame ground- ing conductor to the neutral (white wire), connect the green and white wire from the supply cable of the appliance together and to the neutral (white) wire in the junction box. Connect the remaining wires from the supply cable, matching the colors, to the wires in the junction box.

2.If local codes DO NOT permit frame grounding to the neutral, separate the white and green wires that extend out of the end of the supply cable of the appliance. Connect the white wire from the supply cable to the neutral wire in the junction box.

Connect the black and red wire from the supply cable, matching the colors, to the corresponding wires in the junction box. The green wire MUST now be used to ground the appliance in accordance with local electri- cal codes. Connect the green ground wire to a grounded cold water pipe*or to the grounded lead in the service panel. Do not ground to a gas supply pipe. Do not connect to electrical power supply until

appliance is permanently grounded. Connect the ground wire before turning on the power. See Figure 2.

	GROUNDED COLD
COPPER	WATER PIPE
GROUND WIRE	(REMOVE PAINT, ETC.)

3. INSTALLATION

NOTE:

Before installing the oven in the cutout, it may be helpful to remove the oven door. See details below.

Insert appliance into cut-out. Screws are provided for fastening the front frame of the appliance to the cabinet.

The mounting holes in the front frame of appliance may be used as a template to locate the appliance mounting screw holes.

CAUTION: For your personal safety, and to minimize potential personal injury, this oven must be securely fastened to the cabinet, using the four screws that are provided.

Use caution when mounting oven in cutout so you do not overtighten screws and cause porcelain chippage or puncture oven cavity.

TO REMOVEOVENDOOR-SELF-CLEANINGMODELS

(Door to be removed for installation only).

1.Remove the two screws, one on each side of the inner door panel. See View A.

GROUND CLAMP’ NUTS FIRMLY (MUyNBp;p;yHT

FIGURE 2

*Cold water pipe must have metal continuity to electrical ground and not be interrupted by plastic, rubber or other electrically insulating connectors (including water meter or pump) without adding a jumper wire at these connec-

SCREW (1

VIEWA

\ ’

tions.

CAUTION - If connecting to a four-wire electrical system (MOBILE HOME) the appliance frame MUST NOT be connected to the neutral wire of the four-wire electrical system. Separate the white and green wires that extend out of the end of the supply cable of the appliance. Connect the white, red and black wires from the supply cable, matching the colors, to the corresponding wires in the junction box. Connect the green wire from the supply cable to the ground wire in the junction box.

2.Put an allen wrench (5132” or smaller) or equivalent in the hole in each of the hinges. Close the oven door until the pins touch the oven front. See View 8.

3.The oven door can now be lifted off.

4.Reinstall oven door the same as on non-self cleaning models. (See page 4)

5.Reinstall the door mounting screws.

3