Whirlpool 2180913 manual For, Level unit, Water observe Local codes, Cold water supply

Level unit

1.After placing unit in position, check to make certain the unit is level side-to-side and front-to-back.

2.Accurate leveling is essential for proper operation.

3.Unit should be shimmed so that it is solid as well as level. The shims should be of hard permanent type material such as Masonite.

4.If you are installing this ice maker in a commercial setting that requires National Sanitation Foundation (NSF) installation procedures, NSF requires that the ice maker be sealed to the floor at the bottom rail. For compliance with this NSF sealing procedure, we recommend a silicone-type sealer.

For	The	Plumber
connect	to	water (observe		local codes)
1. Use VI” (6 mm) OD soft copper tubing for			I	RIGHT END VIEW
the cold water supply.
				Y.” 119 mml

2.Provide a convenient manual shut-off valve in the water line.

3.Position the tubing so it can enter the access hole located in the right hand rear of the cabinet. The tubing should extend beyond the cabinet front when the

cabinet is pushed back into position.

NOTES:

Always purge the water line before making the final connection to the inlet of the water valve to prevent possible water valve malfunction.

After the cabinet is in place, bend the tubing to meet the connection at the water valve. The garden hose-threaded compression fitting is found in the parts bag. This joint provides a convenient disconnect for service. Be sure the tubing is clear of compressor to prevent rattle.

BUILT-IN OPENING DIMENSIONS

		1:		:\	‘%
	I	I		I
	900,			-	90”
		34-l/2”
Do Not	kink or	(676	mm)
				--	4-112”
pinch	power
					(114mm)to
supply	cord		,i
					center	line
behveen	ice
maker	and		9” (229	mm)
cabinet.
			max.
	L	16”	(457	mm) --\

l/4” (6 mm)
OD water line			Water
compression
			inlet
fitting	at
			solenoid
water	valve
			valve
	\	/
Bend	field-	\I
water	valve

BACK VIEW

				lT/Bp/s”
			+200	mm)-		-I	4” (102 mm)
							long	5/e” (16-
							mm)	rubber
							drain	tube -
							run	to open
	34%”							drain
	(674	mm]
Hole	for			7%”			(32 mm)
field-			(19	mm)		11Vi”minimum
supplied		I	d7-	6		/	diameter
	3”	L		” -		ii	standpipe
			II J--L
			S”			II-
water	line (767 mm)		e f$l+\-I
			(36	2	9”	(23 mm)
				mm)

4