Whirlpool 3374369 1 yJp+l, Recommended drain hose connection methods, Cut here to cpnnect to

Tilt dishwasher backwards on wheels when moving across floor.

Failure to do so may cause damage to floor covering.

8 B Latch dishwasher door. Push dishwasher into place, sliding drain hose through hole cut in cabinet opening.

Recommended drain hose connection methods:

Drain hose to air gap to waste tee.

air-gap kit

rubber connect0

waste tee <

mrnrmum clearance

to floor

above trap.

Drain hose to air gap to disposer.

nair-gap kit

Alternate drain hose connection methods:

Drain hose to waste tee. , c~n~e~t~r

to fit.

waste tee <

- screw- or spring-type

clamp

20”I clearance

to floor

wEntry must be above trap.

If local plumbing codes permit, dishwasher drain hose may be connected directly to waste tee’. The waste tee connection MUST be made ahead of the trap and a minimum of 20” above the floor.

Do not pinch power supply cord or kink power supply cable between dishwasher and cabinet. Check that front leveling legs are firmly against the floor. Align dishwasher door with cabinet doors, so that spacing is the same on both sides.

9 w Connect drain hose to an air gap or waste tee using one of the

recommended or alternate methods.

Cut hose connector to fit, if needed.

Entry must be above trap.

ny (Part No.

,l-ti-h~O*\

I I

Drain hose to disposer. A&

It hose ztor.

clearance Ill

to floor

1 yJp+l

J

If local plumbing codes permit. dishwasher drain hose may be connected directly to disposer. Most disposers have 7/8” connectors or special

If connecting drain hose to an air gap or waste tee, cut end of drain hose as shown.

Secure drain hose with screw-type or spring-type hose clamp (clamp type varies with models).

Do Not cut drain hose when connecting to a 7/8” disposer connector. Knock out plug from disposer inlet. Secure drain hose with hose clamp provided.

DO NOT cut ribbed section to shorten drain hose.

Numbers correspond to steps.

Install air gap (Par-t No. 300096)’ according to kit instructions. If other brands of air gaps are used, they should be checked to make sure they allow for the same water flow.

Connect the air gap to a waste tee* or disposer using a rubber connector*.

Most disposer have 7/8” connectors or special connectors are available at plumbing supply houses.

Knock out disposer inlet If inlet plug falls inside disposer, you must remove inlet plug before connecting drain hose. If disposer is already installed in sink, you may need to take

out disposer to remov inlet plug.

connectors are available at plumbing supply houses.

Knock out disposer inlet p from inlet. If inlet plug falls inside disposer,

you must remove inlet plug before connecting drain hose. If disposer is already installed in sink, you may need t take out disposer to remove inlet plug.

‘All parts are available through your dealer or local hardware or plumbing store.

Door, access and toe panels not shown.

Cut here to cpnnect to

Drain hose shipped inside tub.

Panel C