Product Damage
Do Not solder within 6” of plastic water inlet valves.
Failure to follow this instruction could result in product damage.
IO n Connect water pipe or tubing directly to water inlet valve. Do Not run pipe or tubing across front of motor or dishwasher legs. Turn on water supply and check for leaks.
11 n Check electrical requirements. Be sure you have correct electrical supply and recommended grounding method. See Panels A and B for proper connection.
top mounting brackets attached to underside of countertop.
12 w Open dishwasher door and remove ail shipping materials. Remove bottom rack. Place a newspaper or large sheet of paper over bottom of dishwasher to protect the pump area when securing dishwasher to countertop.
Personal Injury/Product Damage
Hazard
l The dishwasher must be secured to the countertop to keep it from tilting when door is open.
lDo Not drop screws in dishwasher
~tub. If screws should fall into pump, pump and motor damage may occur.
Failure to follow these instructions may result in personal injury or product damage.
13 n Secure dishwasher to countertop with two, NO.
Do Not drop screws in dishwasher tub.
Remove paper from bottom of dishwasher.
j equally space*
14 w Open door approximately 3” and check for equal spacing between inner door and tub sides. If necessary, loosen screws that fasten dishwasher to countertop and shift tub. Tighten screws.
operation. Door should close easily without slamming and open with its own weight. If necessary, close door and adjust both door springs by moving spring ends to different holes in base.
16 n Take a few minutes to read the Use and Care Guide to fully understand your new dishwasher.
17 n Check that all parts have been installed and no steps were skipped. Check that you have all the tools you started with.
18 w Turn on electric supply. Start dishwasher and allow it to complete a cycle. Check that dishwasher is working properly and that there are no water leaks.
19 w Replace the access panel and toe panel. The toe panel must be positioned to contact floor.
20 w If chanainq color of door and access panel or instairing custom panels, follow the “Tochange door panel color” and ‘To change access panel color” instructions, Panel D and E.
Congratulations!
You have just finished installing your new undercoun ter
dish washer. Keep Installation instructions available for easy reference.
To change door panel color
NOTE:The opposite side of the door color panel is a different color.
Personal Injury Hazard
Wear gloves and handle panels carefully.
Cut metal edges may cause personal iniurv or damage to other materials.
1 n Insert finaer under one
2 l | Lift | |
door | ||
panel(s) | at | |
outer edges. | ||
Use one | hand | |
to | bow | bottom |
of | panel(s). | |
Remove | Do Not | |
panel(s). | ||
remove | spacer. | |
3 Insert one n side of
door panel(s).
with desired color facing out, into one side of door frame.
4 Bow door n panel(s)
and insert other side of door panel(s) into door frame.
control console
5 Push in n on door
panel(s) near the top and slide panel(s) and spacer up inside bottom of control console, allowing panel(s) to rest on channel at bottom
of doors.
6 Snap one end of retainer into W channel as shown, Push inward while sliding thumb along full length of
retainer.
