Drying guidelines
l Always follow care label directions when they are available.
lUse the Fluff Air cycle, or line dry rubber, plastic, delicate, and
lThe last few minutes of all cycles are without heat to make the load easier to handle.
l To help reduce wrinkling, remove the load from the dryer as soon as tumbling stops. This is especially important for permanent press, knits, and synthetic fabrics.
l
l
Overdrying can cause shrinkage, static cling, and damage to some fabrics. Refer to pages
information about:
-sorting clothes for drying
-choosing load sizes
-using dryer fabric softeners
-saving energy
-drying
Cycle descriptions
Automatic cycle(s)
Dry most loads uslng the Energy Preferred Automatic Settlng (t).
Your Automatic cycle(s) shuts off when the selected dryness is reached. The Cycle Control Knob will not move until the load is almost dry. After the
lIf the load is drier than you like, select a setting closer to Less Dry the next time you dry a similar load.
. If the load is not as dry as you like, com- plete drying using a Timed cycle. Select a setting closer to Very Dry the next time you dry a similar load.
Some models offer high heat and low heat Automatic cycles (see page 9).
NOTES:
l Some Automatic cycles use an electronic
l Other Automatic cycles use an automatic
Timed cycle(s)
Use a Timed cycle to complete drying if some items are damp after Automatic drying. Timed drying is also useful for:
l Delicate items and small loads that need a short drying time.
l Bulky items and large loads that require a long drying time.
Some models offer high heat and low heat Timed cycles (see page 9).
Fluff Air cycle
(on some models)
The Fluff Air cycle has no heat. Use this un- heated cycle to fluff or air dry bedding, plastic table- cloths, foam pillows, sneakers, etc. See page 10 for more information about the Fluff Air cycle.
NOTE: If your model does not have the Fluff
Air cycle, line dry
7
