7
3. (OPTIONAL STEP) Pour measured liquid chlorine
bleach into the liquid chlorine bleach dispenser. Bleach
will be diluted automatically during the wash part of the
cycle.
■Never use more than 1 cup (250 mL) for a full load.
Use less with a smaller load size.
■Follow the manufacturer’s directions for safe use.
■To avoid spilling, use a cu p with a po ur in g s po ut. D o
not let bleach splash, drip, or run down into the
washer basket.
■Use only liquid chlorine bleach in this dispenser.
4. (OPTIONAL STEP) Pour measured liquid fabric
softener into the liquid fabric softener dispenser.
Softener is added automatically during the rinse
portion of the cycle.
■Dilute liquid fabric softener by filling the dispe nser
with warm water until liquid reaches the crossbar in
the opening.
■Do not spill or drip any fabric softener on the
clothes.
■Use only liquid fabric softener in this dispenser.
5. Close the washer lid.
6. Turn the LOAD SIZE selector to the correct setting for
your wash load and the type of fabric being washed.
■Choose a load size that allows the load to mov e
freely for best fabric care. See "Loading."
■You may change the load size selection after the
washer has started filling by turning the selector to a
different setting.
7. Set the TEMPERATURE selector to the correct setting
for the type of fabric and soils being washed.
■Your washer uses the ACCUWASH* automatic
temperature control. ACCUWASH maintains a
uniform water temperature by regulating incoming
hot and cold water. This helps eliminate undissolved
detergent and ensures consistent cleaning results.
The cold wash is regulated at approximately 75ºF
(24ºC). The warm wash is maintained at
approximately 100ºF (38ºC).
NOTE: Make sure that both hot and cold water
faucets are turned on or the ACCUWASH feature
will not work properly.
■Use the warmest water safe for fabric.
■Follow garment label instructions.
HOT: 111°F (44°C) or above
– Whites and pastels
– Heavy and greasy soils
WARM: 90° to 110°F (32° to 43°C)
– Bright colors
– Moderate to light soils
COLD: 70° to 90°F (21° to 32°C)
– Colors that bleed or fade
– Light soils
8. (OPTIONAL STEP) For an additional rinse and spin at
the end of a wash cycle, set the EXTRA RINSE selector
to ON.
9. (OPTIONAL STEP) Set the CYCLE SIGNAL selector to
ON if you wan t your washe r to sound a s ignal when t he
wash cycle is finished. The signal is helpful when you
are washing items that should be removed from the
washer as soon as the cycle ends.