b
6.
In jury Hazard
Use two or more people to move and safely install vent system.
Failure to follow this instruction can result in back or other injury.
9 n Insert downdraft vent into countertop cutout. Two people are
recommended to support the weight of the downdraft vent during lifting. Position downdraft vent so it is centered in cutout and parallel to edge of cutout. Check that downdraft vent is level vertically Then fasten lower support legs to cabinet floor with screws. Snap end caps over top of mounting brackets.
Panel D
Numbers correspond to steds.
When attaching undercounter bracket to underside of countertop:
Do Not drill into countertop surface.
Check that mounting screws are proper length and will not go through countertop surface when tightened in place.
10 Attach one undercounter
n bracket on front upper right corner of downdraft vent with slot over vent mounting hole and flange against countertop. Attach other bracket to left side of downdraft vent. Carefully drill starter
holes through undercounter mounting brackets into underside of countertop.
Insert appropriate length screws into holes and tighten brackets to countertop.
11 ’ Disconnect power SUDP~Y. Thread the power supply cable through the knockout opening in the wiring box. Connect the white wires together with a
Top corners of filter frame must press against
microswitch behind filter. ON/OFF
,, button
nTurn power supplv on. Push the
button on the top of the do&draft vent. Retractable section of downdraft vent will rise and blower will start. Turn the control knob on side of vent to check the operation and speed of blower.
If blower does not operate:
l Check that filter frame is pressed in as far as it will go.
l Check that circuit breaker is not tripped or house fuse blown.
l Disconnect power source and check that wire connections have been made correctly.
13 n Connect ductwork to blower Position ductwork to avoid wall studs and floor joists. Complete all ductwork. Use duct tape to seal all joints. Ductwork must end with a wall or roof cap.
14 n Install cooktoo accordina to
manufacturer’s instructions. Check t6at rear edge of cooktop overlaps edge of retractable downdraft vent by 3/8”.
Keep Installation Instructions close to downdraft vent for easy reference.
( Congratulations ! )
~~~:~~;~v~The instructions will make reinstalling
