Common Dishwashing Problems
PROBLEM
spotting and filming
Small particles deposited on items
CAUSEDBY
Hard water
Water is not hot enough
Not enough detergent, or improper detergent
“Old”detergent
Improper loading
No rinse agent
Drying with Energy Saver Option
Spray arm not rotating freely
SOLUTION
Fill detergent dispensers to capacity. Use dishwasher detergent with highest available phosphorus content. May be necessary to install water softener.
To remove spots and fihn, try a vinegar rinse ...
1.Wash and rinse load as usual. Use the Energy Saver Dry Option.
2.Remove all metal items.
3.Put 2 cups (506 mL) white vinegar in a container on the bottom rack.
4.Run dishwasher through a complete washing cycle.
Water temperature should be at least 140°F(60%). Set water heater thermostat to a higher setting. Run water at sink until hot before starting.
Use more dishwasher detergent. Use detergent with highest available phosphorus content ...
especially with hard water.
Use only fresh dishwasher detergent. Store tightly closed container in cool, dry place. Discard old detergent. Do not fill dispensers until ready to start dishwasher.
Make sure dishes and glassware are loaded so spray reaches all surfaces and items drain properly. Do not overload. Do not nest items.
Make sure large items do not block spray from reaching detergent dispensers.
Does the rinse agent dispenser need filling? Seeinstructions on page 9.
Drying without heat may result in some spotting of glasses and silver. Dry with heat.
Check spray arm to make sure it turns freely after loading. Be sure a utensil has not prevented it from turning.
continued on next page
Page 11
