Before You Call For Service
If you are having an operating problem, check the list to see what the cause might be before you call for assistance.
OPERATING PROBLEM |
| CHECK IF’ | ||
Dishwasher | will not run, or | . | Dishwasher is properly connected | |
stops during | a cycle. |
| to a live circuit with the proper | |
|
|
|
| voltage. |
|
|
| n | Home fuse or circuit breaker has |
|
|
|
| blown or tripped. |
|
|
| . Water is turned on. | |
|
|
| n | Motor has stopped because of an |
|
|
|
| overload. |
|
|
| n | Door is tightly closed and securely |
|
|
|
| latched. |
|
|
| . Cycle has been correctly set. | |
Dishwasher | won’t | fill. | n | Overfill protector is stuck in “up” |
|
|
|
| position. |
Water remains in the | . | The cycle has completed. | ||
dishwasher. |
|
|
|
|
|
|
| . Dram air gap is clogged. | |
Detergent remains | in the | . | The bottom rack is in properly. | |
covered detergent | cup. |
|
|
. The dishwasher detergent is fresh and dry without lumps.
m The cycle has completed.
WHATTODO
H Contact qualified service technician to reconnect dishwasher to electrical supply. (SeeInstallation Instructions.)
m Replace fuse or reset circuit breaker.
H Open water valve to dishwasher.
nMotor will automatically reset itself within a few minutes. If the motor does not start, call for service.
nPress firmly against door.
nReset cycle following steps on page 4, 5 or 6.
nOverfill protector should move up and down freely. Press down to release.
nWait for the cycle to finish. A small amount of remaining water is normal.
aClean dram air gap. (See Installation Instructions.
nPlace the rack with the rack bumpers at the front.
nReplace old detergent with fresh.
I Wait for the cycle to finish.
White residue appears on front of access panel.
Dishes aren’t as dxy as you
expected.
nToo much detergent is being used.
nYour liquid detergent is developing excess foam and building up on exterior of accesspanel.
. Rinse agent dispenser is empty.
nSeepage 8 for recommended amounts of detergent.
nTry a different brand to reduce foaming and eliminate
nFill rinse agent dispenser. Using a rinse agent greatly improves drying. (Seepage 9.)
Page 15