Whirlpool 50 manual Shipboard Operation, Changing The Bin Door Panel, Thermostat Calibrations

CHANGING THE BIN DOOR PANEL

The storage bin door is designed to accept an	THERMOSTAT CALIBRATIONS
optional decorative wood panel of your choice.

The wood panel should be no more than ‘A inch (6 mm) thick. Cut it to the same size as the

production metal panel. See Figure 1.

To change the panel:

1.Open the bin door.

If ice maker is installed above two thousand feet of

altitude, the bin and evaporator thermostats must

be adjusted to a warmer setting. Disconnect

electricity, remove thermostat and follow the

directions for turning the altitude adjustment screw as shown in the label on each thermostat.

SHIPBOARD OPERATION

2.Remove the two screws on top of the door

which hold

the

handle.

When

this

ice cube

maker

is

installed

aboard

a ship,

it

will

be

necessary

to

purchase

and install a water

3.

Remove

the

handle.

deflector.

This

deflector

hangs

between

the

lower

edge

of

the evaporator

and

the

cutter

grid.

It keeps

4.

Slide

the

metal

panel

out.

the

water

flowing

over

the

evaporator

from

spilling

into

the

storage

bin

area.

Order

the

necessary

parts

5.

Break

off

the

ribs

on

the door insulation

to

from

your

local

ice

maker

dealer.

allow

for

the

wood

thickness.

See Figure 2.

6.Slide the wood panel into the door frame.

7.Replace handle and screws.

WOOD

13-3116”PANEL DIMENSIONS

REMOVE ALL DOOR INSULATION

RIBS TO ACCEPT WOOD PANEL

THICKNESS

FIGURE 2

2