UNIT WIRING DIAGRAM
This model operates at 115 volts except for the cutter grid circuit which operates at 8.5 volts at 1 amp.
he compressor runs at all times except when the
bin thermostat becomes satisfied and opens up. This
Under normal operating conditions, when the
evaporator reaches the preset temperature (+lO’
to
evaporator thermostat opens, terminating op- eration of the fan motor and pump motor. The hot gas solenoid and the water valve solenoid are
energized at this time and remain so until the
evaporator reaches 38 + 2’ F.
DANGER: ELECTRIC SHOCK HAZARD
DISCCNNECTKhvER BEFORE SERVICIW LN,T
MAXIMUM FUSE SIZE: ISaMPs
NOTE‘CCWT.TS?+43’“4IN FREEZINGCYCLE
CUBELET CUTTER GRIDS
I-
8
CUBE CUTTER GRID
FUSE GRID
YOUR UNIT MAY OR MAY NOT BE EQUIPPED WITH A CUTTER GRID FUSE.
1%” x 1%” Cube Grid
”
CHECK OPERATION
v Start the unrt by turnrng the service switch to “ON” and opening the line water valve.
vNOTE: Left is “OFF” - Middle is “ON” - Right
is “CLEAN.” In “CLEAN” position, only the pump operates.
vCheck condenser fan to make sure it is revolving.
vWater will not enter pump pan until freezing plate gets cold and machine goes into a harvest cycle.
vCheck for even water flow over freezing plate. Unit must be level for proper operation.
vCheck for desired cube thickness and after 24
hours adjust if necessary. Maximum ice yield will be obtained with ice thickness at J/2” to H”.
vReplace grill.
7