Whirlpool 66126277 To Select the Mode, To Select Dry Mode, To Select the Fan Speed (Fan, Cool or Heat [heating models only]) , To Set the Temperature To raise the temperature:, To lower the temperature:, To Set the Time of Day, To Set the Timer Delay To set the Timer to turn on the air conditioner, keeping previous settings: , To set the Timer to turn on the air conditioner, changing the previous settings:

11
To Select the Mode
NOTE: To select Dry mode, see “To select the Dry mode” later in
this section.
1. Press MODE to choose Fan, Cool, Heat (heating models only)
or Auto.
The following symbols will be displayed.
■Fan—Fan mode.
■Snowflake—Cool mode.
■Sun—Heat mode (heating models only).
■Tria ngl e—Auto mode.
2. Press SEND to activate the mode.
3. To adjust the temperature or fan speed, select -ºF, + ºF or
FAN.
4. Press SEND.
To Select Dry Mode
NOTE: The Send button does not have to be pressed to activate
the Dry mode.
1. Press POWER to start the air conditioner.
2. Press DRY to select the Dry mode.
The following symbols will be displayed.
■Tea rdr op —Dry mode
■Tria ngl e—Auto mode
NOTE: Pressing DRY again will select the Auto mode.
To Select the Fan Speed (Fan, Cool or Heat [heating
models only])
1. Press FAN.
2. Choose High, Med or Low.
3. Press SEND to activate the fan speed.
To Set the Temperature
To raise the temperature:
Press the plus button to increase the temperature 1º.
To lower the temperature:
Press the minus button to decrease the temperature 1º.
NOTE: Press SEND to activate temperature change.
To Set the Time of Day
Time of day is always displayed on the remote cont rol display.
1. Press the Hr button until the correct hour appears on the
display.
2. Press the Min button until the correct minutes appear on the
display.
To Set the Timer Delay
To set the Timer to turn on the air conditioner, keeping
previous settings:
1. Turn off air conditioner.
2. Press TIMER. Remote control display will show remaining
hours before air conditioner will turn on.
3. Press the Hr button to change delay time (1 to 18 hours).
4. Press SEND. Remote control display will show remaining
hours before air conditioner will turn on.
To set the Timer to turn on the air conditioner, changing
the previous settings:
1. Turn on air conditioner.
2. Adjust Mode to Fan, Cool, Dry, Heat (heating models only) or
Auto.
3. Press SEND.
4. Adjust Fan Speed to High, Med or Low.
5. Press SEND.
6. Adjust temperature between 64°F (18ºC) and 86°F (30ºC).
7. Press SEND.
8. Wait 3 seconds before turning off air co nditioner.
MODE
COOL
FAN HEAT AUTO
LMH
SEND
DRY
AUTO
LMH
DRY
FAN
+ºF
-ºF
Hr
Min
TIMER