Whirlpool 6ADG 7554 WHM S E R V I C E, Technical data, Dimension, Electronic boards, Alarms

08.08.2002 / Page 2	6ADG 7554 WHM	Whirlpool Europe	S E R V I C E
Doc. No: 4812 718 18228	8542 554 53710	Customer Service

Technical data

Dimension
Height		82.0 - 87.0cm
Width		59.7	cm
Depth		55.5	cm
Weight		52	kg
Wooden door for Full Door appliances
Thickness min.		16	mm
Thickness max.		20	mm
Width min.		592	mm
Width max.		595	mm
Height min.		620	mm
Height max.		718	mm
Weight min.		2.5	kg
Weight max.		6.5	kg
Max. stick out over lower
edge of appliance door		92	mm
Height of plinth min.		93	mm
Electronic boards
Service boards		see spare part list
Serial boards		see on the boards itself
DUB		4619 720 80502
Programing of version and programmed control
board, see „Service“ and „Data set“ on rating
plate of inner door:
CB programmed		464711
Data set		464701
Basic control board, not programmed see on the
board itself		4619 724 17441
Succession of programs
Programs		see program diagram
Succession	A1a - A3a - A5b - A6a - A7a

Alarms

Refill rinse aid

Options

Zone washing

Program information

End - Acoustic signal

All programs will be locked after start. Changing the program or finishing the program will be possible only after pressing the start button for longer then 1.5 sec. (Break by customer)

A switching off the appliance or unplug the appliance for a while, this will frozen the program step and later on, the program continuos on the same position.

Exception: Switching off the appliance or unplug the appliance during the drying phase, this will lead directly to the end of the program.

Water Volume at alternating spray system

Volume at alternating spray system (same level when selected zone washing as in the normal programs)

Water	Volume	Level
Regeneration	0.3 l	15 mm
Back rinse 3x	1.0 l	60 mm
Prewash	3.9 l	120 mm
Main wash	3.2 l	118 mm
Intermediate rinse 1	3.2 l	118 mm
Intermediate rinse 2	3.2 l	118 mm
Clear rinse	3.2 l	118 mm
Safety/ overflow	8.5 l	141 mm

Measuring the level

Remove the coarse sieve, put in a measuring meter into the sump, measure the hight of the water level.

Detergent max.
Pre-wash	10	cm3
Main-wash	40	cm3
Rinse aid	135	cm3
6 Dosage steps	1 - 6	ml
Water pressure
Inlet pressure	0.3 - 10	bar
Spray pump pressure	0.3	bar
Rotations
Spray pump motor	2800	RPM
Drain pump motor	3000	RPM
Spray arm lower	30 - 40	RPM
Spray arm upper	30 - 40	RPM