Cycle
China Crystal
A light wash with a gentle dry designed for china and crystal.
l-
IP\ ‘0” shows what ste?P!s are in each I C! ycle!I Cycle
MainTime Vash Iinse Vash Iinse Iinse DV Minutes)
NOTE: The Cycle Control knob | . | l t | . | 60’ | |||
does not move | while the dishwasher | ||||||
|
|
|
|
| |||
heats water to 135°F (57%) in the final rinse (marked t) if the
Rinse & Hold
. | 0 | 16 |
use detergent. Use Air Dry option. Drying with heat may cause food to bake on dishes.
l Cycle time includes heated dry time. Cycle time may vary depending on the temperature of the water entering the dishwasher.
What happens in each
A note about water heating
The dishwasher can heat water during portions of all cycles except Rinse & Hold.
NOTE:
l The WATER HEATING signal light will glow while the water is heating.
. The Cycle Control knob does not move while the water is heating.
l When the water temperature reaches 135°F (57°C) the Cycle Control knob will begin moving again.
l The heating time is based on the tempera- ture of the water suppty as it enters the dishwasher. The cooler the water, the longer the heating time.
If water temperature at the faucet is below 120°F (49°C) have a qualified person raise the water heater’s thermostat setting. See page 16.
option
l The dishwasher does not pause to heat the water if the water entering the dish- washer is already 135°F (57°C).
10
