Whirlpool 8900 manual Solution

Cycle Takes

mremely Long

Time

Dishes Do Not Dry Completely

Silica Film or Etching (Silica Film is a White Irides- cent Deposit; Etching is a Cloudy Film)

Black or Gray Marks on Dishes

Cause

Water temperature is tot

IOW

Use of incorrect deter- gents

Incorrect amount of detergent

Use of ineffective detergents

Insufficient fill caused by low water pressure

Water temperature is tot low

Dishes do not drain wwb

Plastics

A water chemical reaction with certain types of glassware. Usually caused by some combination of soft or softened water, alkaline washing solutions, insufficient rinsing, over- loading the dishwasher, and heat of drying.

Aluminum items

Solution

Use the Hi-Temp Wash option and do not use the Lo-Energy Rinse option. If needed, turn home water heater up to ensure water entering dishwasher is 120°F (49°C) minimum. See recorn- mended procedure on page 15.

Use recommended dishwasher deter- gents only.

Follow recommendations on pages 12 and 13 for amount. Heavy soil and/or hard water generally require extra detergent.

Detergent should be fresh. Store in a cool, dry place, preferably in an airtight container. Discard lumpy detergent.

Home water pressure should be 20 to 120 psi for proper dishwasher fill. A booster pump on the water supply may be neces- safv if pressure is too low.

If needed, turn home water heater up to ensure water entering dishwasher is 120°F (49°C) minimum. See recom- mended procedure on page 15.

Dishes must have proper water drainage. Do not overload. Follow instructions for loading dishwasher on pages 17-20. Use a liquid rinse agent to speed draining.

Some plastics, due to material, may need to be towel dried.

It may not be possible to prevent problem, except by hand-washing. To slow this process, use a minimum amount of detergent but not less than one table- spoon per load. Use a liquid rinse agent and underload the dishwasher to allow thorough rinsing. Silica film and etching are permanent and can not be removed. Use the Air Dry option.

Aluminum items should be loaded so

that they will not rub against dishes during washing. Throw-away aluminum items should not be washed in the dishwasher because they may break down and cause marking. Aluminum markings can be removed by using a mild abrasive cleanser.

continued on next page 23