3.Turn the Cycle Control knob clockwise to point to the desired cycle. Heavy Wash and Pots 8 Pans cycles share the same spot on the dial. China Crystal and Light Wash cycles also share a spot on the dial. The Cycle Selector buttons deter- mine which cycle operates. You will feel a definite stop at each cycle mark. The dishwasher will automatically start the cycle you selected.
NOTE: If the door is latched, you will hear cycles start and stop as the knob passes each cycle mark. This is normal and will not hurt the dishwasher. If you prefer, you can set cycles with the door unlatched.
Starting your dishwasher using delay wash
You can set the dishwasher to start a cycle from 1 to 6 hours later.
1.Push desired Cycle Selector button.
2.Push desired Option Selector button(s).
3.Turn Cycle Control knob clockwise to the number of hours (from 1 to 6 hours) you want the dishwasher to delay before the selected cycle starts.
4.Close and latch the door. The DELAY signal light will come on until the selected cycle starts.
NOTE:
l You can add items while time is counting down. Close and latch the door. The Cycle Control knob will not advance if the door is unlatched.
l Rinse & Hold, Light Wash and China Crystal cycles cannot be delayed.
Adding a dish during a cycle
You can add a forgotten item to the dishwasher reaches LIGHT WASH. See page 9.
1.Lift up on the door latch to unlatch the door and stop the cycle. Wait a moment for the spray action to stop before open- ing the door.
2.Open the door and add the dish.
3.Close the door. Do not latch it. Wait 30
anytime before the Cycle Control knob
seconds for air in the dishwasher to warm up. This helps reduce the amount of moisture that can come from the vent when restarting the cycle.
4.Press door in to latch ft. The dishwasher will start where it stopped.
7
