Troubleshooting
Before calling for assistance please check the chart below for problems you can fix. It could save you the cost of a service call.
Dishwasher
PROBLEM
Dishwasher does not run or stops during a cycle
Dishwasher runs too long
Dishwasher will not fill
Water remains in dishwasher
Detergent remains In covered section of dispenser
Dishes not as dry as you expected
Grinding, grating, crunching, or buzzing sounds
White residue appears on front of access panel
problems
CHECK THE FOLLOWING
Is the door tightly closed and securely latched?
Has the cycle been set correctly?
Is the dishwasher set for a delay start?
Has a household fuse or circuit breaker blown or tripped?
If the motor stopped because of an overload, it will automatically reset itself within a few minutes. If it does not start, call for service.
Is the water supply turned on?
Is the dishwasher wired into a live circuit with the proper voltage?
Cycle times depend on the temperature of the water entering the dishwasher. Cooler water results in longer cycle times.
Undercounter dishwashers require adequate enclosure for proper operation. See Installation Instructions for complete information.
Is overfill protector stuck in “up”position? Overfill protector should move up and down freely. Press down to release. See the “Caring for Your Dishwasher” section, on page 19.
Allow cycle to finish. A small amount of water remaining is normal.
Check the drain air gap (if installed). If it is clogged, follow the manufacturer’s cleaning instructions.
Has the cycle completed?
Is the detergent fresh and dry without lumps? See the “Using the Dispensers” section, on page 11.
Is the bottom rack in backwards? The rack bumpers must face the dishwasher door.
Is the rinse agent dispenser empty? Using a rinse agent greatly improves drying.
Do not use Air Dry option on the next load. See the “Setting the Controls” section, on page 13.
Has a hard object entered the POWER CLEAN* module? The sound should stop when the object is ground up.
Is too much detergent being used? See the “Usingthe Dispensers” section, on page 11, for recommended amounts of detergent.
Some liquid detergents develop excess foam and residue on panel. Try a different brand to reduce foaming and eliminate buildup.
continued on next page
27
